#########################################################

[exclude_object]

[gcode_macro M486]
gcode:
# Parameters known to M486 are as follows:
# [C] Cancel the current object
# [P] Cancel the object with the given index
# [S] Set the index of the current object.
# If the object with the given index has been canceled, this will cause
# the firmware to skip to the next object. The value -1 is used to
# indicate something that isn’t an object and shouldn’t be skipped.
# [T] Reset the state and set the number of objects
# [U] Un-cancel the object with the given index. This command will be
# ignored if the object has already been skipped

{% if ‘exclude_object’ not in printer %}
{action_raise_error(“[exclude_object] is not enabled”)}
{% endif %}

{% if ‘T’ in params %}
EXCLUDE_OBJECT RESET=1

{% for i in range(params.T | int) %}
  EXCLUDE_OBJECT_DEFINE NAME={i}
{% endfor %}

{% endif %}

{% if ‘C’ in params %}
EXCLUDE_OBJECT CURRENT=1
{% endif %}

{% if ‘P’ in params %}
EXCLUDE_OBJECT NAME={params.P}
{% endif %}

{% if ‘S’ in params %}
{% if params.S == ‘-1’ %}
{% if printer.exclude_object.current_object %}
EXCLUDE_OBJECT_END NAME={printer.exclude_object.current_object}
{% endif %}
{% else %}
EXCLUDE_OBJECT_START NAME={params.S}
{% endif %}
{% endif %}

{% if ‘U’ in params %}
EXCLUDE_OBJECT RESET=1 NAME={params.U}
{% endif %}

########################################################